Edge To Edge; Ep Setup; Ep Defaults; Fuser Temperature (Fuser Temp) - Dell 5230dn Mono Laser Printer Service Manual

•
To change a digit or character, press
•
When the last digit is changed, press
If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on the
screen.
If the process is successful, Submitting Selection appears on the display, followed by the current
value for Confirguration ID 2.
4. Repeat the steps for entering the Configuration ID, and press
If the Configuration ID 2 is validated, Submitting Selection appears, and a check
Printer Setup.
5. Restart the printer.

Edge to Edge

When this setting is On, the text and graphics are shifted to the physical edges of the paper for all margins.
When the setting is Off, the normal margins are restored.

EP SETUP

EP Defaults

This setting is used to restore each printer setting listed in EP SETUP to its factory default value. Sometimes
this is used to help correct print quality problems.
To restore EP Defaults:
1. Select EP Defaults from EP SETUP.
2. Select Restore to reset the values to the factory settings, and select Do Not Restore to exit without
changing the settings.

Fuser Temperature (Fuser Temp)

This adjustment can be used to help solve some customer problems with paper curl on low grade papers and
problems with letterheads on some types of media.
The fuser temperature can be adjusted to: Normal, Lower, Lowest. The default is Normal.

Fuser Page Count

The fuser page count can only be viewed and cannot be changed.
To view the Fuser Page Count:
1. Select Fuser Page Count from EP SETUP.
2. Press Back

Warm Up Time

You can change the amount of time the printer warms up before allowing pages to print by changing this setting
from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets the backup roll heat up
and helps reduce curl in some environments.

Transfer

The transfer can be adjusted to Low, Medium, or High. The default setting is Medium.
to increase or
to return to PRINTER SETUP.
to decrease the value.
to validate the Configuration ID 1.
.
appears next to
3-21
Diagnostic aids