Table of Contents
Advertisement
RRP6.5
CAM ASSY-2ND (PL 6.1.11)
[Removal]
1)
Remove COVER ASSY RH. (RRP 1.12)
2)
Remove LEFT COVER. (RRP 1.10)
3)
Remove FUSER CHUTE ASSEMBLY, BIAS TRANSFER ROLL(BTR) COVER. (RRP 6.1)
4)
Remove 2ND BTR ASSY. (RRP 6.4)
It is not necessary to remove WIRE ASSY 2BTR (PL 6.1.30) from PLATE BIAS-2ND
ASSY (PL 6.1.23) when carrying out the work shown below.
5)
Remove PLATE BIAS-2ND ASSY. (RRP 6.11)
It is not necessary to remove PHOTO SENSOR: 2BTR RETRACT (PL 6.1.19) from
BRACKET-PHOTO SENSOR (PL 6.1.35) when carrying out the work shown below.
6)
Remove PHOTO SENSOR: 2BTR RETRACT. (RRP 6.9)
Pay attention not to drop or loose BEARING when carrying out the work shown below.
7)
Remove an E ring that fixes the right side shaft of CAM ASSY-2ND (PL 6.1.11) to the main
unit and move BEARING (PL 6.1.12) to left side.
When carrying out the work shown below, it will become easier if BIAS TRANSFER
ROLL(BTR) FRAME ASSEMBLY is pushed in the arrow direction and released BIAS
TRANSFER ROLL(BTR) FRAME ASSEMBLY from the cam section of CAM ASSY-2ND.
8)
Move CAM ASSY-2ND to right side once, pull out the shaft of CAM ASSY-2ND from the left
side bearing of the main unit and remove CAM ASSY-2ND together with BEARING.
9)
Remove BEARING from CAM ASSY-2ND.
[Replacement]
1)
Attach BEARING (PL 6.1.12) to the left side bearing of the main unit.
2)
Attach BEARING to the right side shaft of CAM ASSY-2ND (PL 6.1.11).
When carrying out the work shown below, it will become easier if BIAS TRANSFER
ROLL(BTR) FRAME ASSEMBLY is pushed in the arrow direction and released from the
cam section of CAM ASSY 2ND.
3)
After placing the right side shaft of CAM ASSY-2ND in the right side bearing of the main unit,
move CAM ASSY-2ND to left side and attach CAM ASSY-2ND together with BEARING.
4)
Place the right side BEARING of CAM ASSY-2ND in the right side bearing of the main unit
and fix it with an E ring.
Check that cam of CAM ASSY-2ND matches the cam holder of BIAS TRANSFER
ROLL(BTR) FRAME ASSEMBLY.
5)
Attach PHOTO SENSOR: 2BTR RETRACT. (RRP 6.9)
6)
Attach PLATE BIAS-2ND ASSY. (RRP 6.11)
7)
Attach 2ND BTR ASSY. (RRP 6.4)
8)
Attach FUSER CHUTE ASSEMBLY, BIAS TRANSFER ROLL(BTR) COVER. (RRP 6.1)
9)
Attach LEFT COVER. (RRP 1.10)
10) Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 199
Advertisement
Chapters
Table of Contents
