Table of Contents
Advertisement
RRP7.4
RIGHT IBT GUIDE ASSEMBLY (PL 7.1.12)
[Replacement]
1)
Match the boss and the convex of RIGHT IBT GUIDE ASSEMBLY to the hole in the main unit
and attach RIGHT IBT GUIDE ASSEMBLY.
2)
Fix RIGHT IBT GUIDE ASSEMBLY to the main unit using the six screws (silver, with a
flange, tap, 6mm).
Pay attention to setting direction of DIODE when carring out the work shown below.
Mount the diode in a way that the white paint side of the diode is oriented to the side
jointly fastened with RIGHT IBT GUIDE ASSEMBLY.
3)
Attach PLATE-ASSY GND and fasten both PLATE-ASSY GND and RIGHT IBT GUIDE
ASSEMBLY to the main unit using a screw (silver, with a flange, tap, 6mm) to fix them.
4)
Fix the front part of DIODE on the RIGHT IBT GUIDE ASSEMBLY using a screw and attach
DIODE.
5)
Fasten both RIGHT IBT GUIDE ASSEMBLY and the rear side of DIODE to the main unit
using a screw (silver, with a flange, tap, 6mm) and fix them.
6)
Attach SPRING-LATCH to the main unit and the stud section of the RIGHT IBT GUIDE
ASSEMBLY.
7)
Attach WIRE ASSY 1 BTR, WIRE ASSY IBT and WIRE ASSY BCR to RIGHT IBT GUIDE
ASSEMBLY.
8)
Attach PLATE-TR-0 to LEFT IBT GUIDE ASSEMBLY and RIGHT IBT GUIDE ASSEMBLY.
9)
Fix PLATE-TR-0 to LEFT IBT GUIDE ASSEMBLY and RIGHT IBT GUIDE ASSEMBLY
using the two screws (silver, with a flange, tap, 6mm).
10) Attach IBT SENSOR. (RRP 7.1)
11) Attach BCR CLEANING ASSEMBLY. (RRP 7.5)
12) Attach VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
13) Attach 2ND BTR ASSY. (RRP 6.4)
14) Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 226
Advertisement
Chapters
Table of Contents
