Dell 3010CN Service Manual page 167

RRP3.5 DRIVE ASSY FEED 250 (PL 3.2.2)
[Removal]
1) Remove 250 SHEET FEEDER LEFT COVER. (RRP 3.2)
2) Remove CLUTCH ASSY PH. (RRP 3.7)
When carrying out the work shown below, leave the relay connector of SOLENOID FEED
connector (P/J610) on the harness side.
3) Release the two clamps and remove the harness and then remove connector (P/J446) on
PWBA MOT (PL 3.2.11) and connector (P/J610) of SOLENOID FEED (PL 3.2.3).
Screws used to fix four corners (
for the work shown below, and for other work, they should not be removed.
4) Remove four screws (silver, 6mm) that fix DRIVE ASSY EEED 250 (PL 3.2.2) on 250 SHEET
FEEDER ASSEMBLY.
5) Remove the convex on the right side of DRIVE ASSY FEED 250 from 250 SHEET FEEDER
ASSEMBLY and remove DRIVE ASSY FEED 250.
[Replacement]
1) Put the convex on upper right side of DRIVE ASSY FEED 250 to the notch of 250 SHEET
FEEDER ASSEMBLY. Match the holl of DRIVE ASSY FEED 250 to the boss of 250 SHEET
FEEDER ASSEMBLY and attach it.
2) Fix DRIVE ASSY FEED 250 to 250 SHEET FEEDER ASSEMBLY using four screws (silver,
6mm).
3) Attach connector (P/J446) on PWBA MOT and connector (P/J610) of SOLENOID FEED and
then fixes the harness using two clamps.
4) Attach CLUTCH ASSY PH. (RRP 3.7)
5) Attach 250 SHEET FEEDER LEFT COVER. (RRP 3.2)
Chapter 3 Removal and Replacement Procedures (RRPs)
marks) of DRIVE ASSY FEED 250 shall be removed
3 - 69