Table of Contents
Advertisement
RRP5.8
SENSOR (PL 5.2.16)
[Removal]
1)
Remove VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
2)
Remove a screw (silver, with a flange, tap, 8mm) that fixes BRACKET-SENSOR OHP (PL
5.2.15) to VERTICAL TRANSPORT ASSEMBLY (PL 5.2.1).
VERTICAL TRANSPORT ASSEMBLY and BRACKET-SENSOR OHP are connected
with harness, so they should not be set far apart when carrying out the work shown
below.
3)
Remove BRACKET-SENSOR OHP from VERTICAL TRANSPORT ASSEMBLY together with
SENSOR (PL 5.2.16).
4)
Remove connector (P/J101) of SENSOR.
5)
Remove a screw (silver, tap, 8mm) that fixes SENSOR to BRACKET-SENSOR OHP.
6)
Remove SENSOR from BRACKET-SENSOR OHP.
[Replacement]
1)
Match the boss of SENSOR to the hole in BRACKET-SENSOR OHP, and attach SENSOR to
BRACKET-SENSOR OHP.
2)
Fix SENSOR to BRACKET-SENSOR OHP using a screw (silver, tap, 8mm).
3)
Attach connector (P/J101) of SENSOR.
4)
Match the hole in BRACKET-SENSOR OHP to the boss of VERTICAL TRANSPORT
ASSEMBLY, and attach BRACKET-SENSOR OHP and SENSOR.
5)
Fix BRACKET-SENSOR OHP to VERTICAL TRANSPORT ASSEMBLY using a screw (silver,
with a flange, tap, 8mm).
6)
Attach FRAME-ASSY-PH. (RRP 5.3)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 173
Advertisement
Chapters
Table of Contents
