Dell 3010CN Service Manual page 350

RRP9.7 DEVELOPER ROTOR FRAME ASSEMBLY(PL 9.2.9)
[Replacement]
1) Attach BEARING BALL (PL 9.2.14) to DEVELOPER ROTOR FRAME ASSEMBLY(PL 9.2.9).
2) Match DEVELOPER ROTOR FRAME ASSEMBLYto the fitting place so that its gear part
comes to the left side and attach it.
3) Place the shaft of SHAFT ASSY-ROTARY in the hole of DEVELOPER ROTOR FRAME
ASSEMBLYand fix DEVELOPER ROTOR FRAME ASSEMBLYto the main unit.
4) Fix SHAFT ASSY-ROTARY at the left side of the main unit using the two screws (silver, with
a flange, 6mm).
5) Fix SHAFT ASSY-ROTARY at the right side of the main unit using the two screws (silver,
with a flange, 6mm).
6) Attach BRACKET ASSY 2ND GEAR and GEAR 2ND to the main unit.
7) Fix BRACKET ASSY 2ND GEAR to the main unit using the three screws (silver, with a
flange, 6mm).
8) Attach PLATE LEFT to the main unit using the two screws (silver, with a flange, 6mm).
9) Attach HOUSING ASSY-DEVE. (RRP 9.6)
10) Attach PHOTO SENSOR. (RRP 9.5)
11) Attach DEVELOPER LATCH ASSEMBLY. (RRP 9.1)
12) Attach PHOTORECEPTOR MOTOR. (RRP 11.6)
13) Attach DEVELOPMENT MOTOR. (RRP 11.5)
14) Attach IBT CLEANING DRIVE ASSEMBLY. (RRP 11.2)
15) Attach RIGHT IBT GUIDE ASSEMBLY. (RRP 7.4)
16) Attach LEFT IBT GUIDE ASSEMBLY. (RRP 7.2)
17) Attach CHASSIS ASSY ESS. (RRP 12.10)
18) Attach LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
19) Attach PWBA MCU. (RRP 12.6)
20) Attach LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
21) Attach MULTIPURPOSE FEEDER COVER. (RRP 1.7)
22) Attach LEFT COVER. (RRP 1.10)
23) Attach TOP COVER. (RRP 1.1)
24) Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 252