Dell 3010CN Service Manual page 263

RRP5.4 CLUTCH ASSY PH: REGI (PL 5.2.2)
[Removal]
1) Remove VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
2) Remove MOTOR-PH. (RRP 5.11)
3) Remove GEAR ASSY DRIVE. (RRP 5.14)
When carrying out the work shown below, leave the relay connector on the harness side.
4) Remove connector (P/J203) of CLUTCH ASSY PH: REGI (PL 5.2.2) and remove harness of
CLUTCH ASSY PH: REGI from the groove of VERTICAL TRANSPORT ASSEMBLY.
5) Remove an E ring that fixes CLUTCH ASSY PH: REGI to VERTICAL TRANSPORT
ASSEMBLY.
6) Remove CLUTCH ASSY PH: REGI from VERTICAL TRANSPORT ASSEMBLY.
[Replacement]
1) Match the hole position of CLUTCH ASSY PH: REGI to the D-cut section of the shaft of
ROLL-REGI (PL 5.2.4) and attach CLUTCH ASSY PH: REGI in such a manner that the
convex of VERTICAL TRANSPORT ASSEMBLY is placed in the concave of CLUTCH ASSY
PH: REGI.
2) Fix CLUTCH ASSY PH: REGI to VERTICAL TRANSPORT ASSEMBLY using an E ring.
3) Attach connector (P/J203) of CLUTCH ASSY PH: REGI and lay harness of CLUTCH ASSY
PH: REGI to the groove of VERTICAL TRANSPORT ASSEMBLY.
4) Attach GEAR ASSY DRIVE. (RRP 5.14)
5) Attach MOTOR-PH. (RRP 5.11)
6) Attach FRAME-ASSY-PH. (RRP 5.3)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 165