Table of Contents
Advertisement
RRP3.19 ROLL ASSY FEED (PL 3.3.11)
[Removal]
1)
Remove 250 SHEET PAPER TRAY. (RRP 2.1)
2)
Remove 250 SHEET FEEDER LEFT COVER. (RRP 3.2)
3)
Remove CLUTCH ASSY PH. (RRP 3.7)
4)
Remove DRIVE ASSY FEED 250. (RRP 3.5)
5)
Remove HOUSING ASSY FEED. (RRP 3.14)
6)
Remove two screws (silver, tap, 8mm) that fix COVER FEED (PL 3.3.13) to HOUSING ASSY
FEED.
7)
Remove COVER FEED from HOUSING ASSY FEED.
8)
Remove E rings that fix both sides of SHAFT FEED (PL 3.3.12) from HOUSING ASSY FEED,
and remove left and right BEARING EARTH (PL 3.3.9).
9)
First slide SHAFT FEED to the right and pull SHAFT FEED out from the left side bearing of
HOUSING ASSY FEED, and remove SHAFT FEED together with ROLL ASSY FEED (PL
3.3.11) and ROLL SUPPORT (PL 3.3.10).
10) Release the hook of the right side ROLL SUPPORT that fixes ROLL SUPPORT to SHAFT
FEED, and remove ROLL SUPPORT.
11) Release the hook of ROLL ASSY FEED that fixes ROLL ASSY FEED to SHAFT FEED, and
remove ROLL ASSY FEED.
[Replacement]
Pay attention to fitting direction of ROLL ASSY FEED when carrying out the work shown
below.
1)
Attach ROLL ASSY FEED to SHAFT FEED so that the hook is directed rightward, and fix the
hook of ROLL ASSY FEED to the groove of SHAFT FEED.
2)
Attach ROLL SUPPORT to SHAFT FEED, and fix the hook of ROLL SUPPORT to the groove
of SHAFT FEED.
3)
After placing the right side of SHAFT FEED in the right side bearing of HOUSING ASSY
FEED, slide SHAFT FEED to the left and attach it together with ROLL ASSY FEED and
ROLL SUPPORT.
4)
Match the double D-CUT face of BEARING EARTH to the right and left sides bearing of
HOUSING ASSY FEED, attach BEARING EARTH and then fix the both sides of SHAFT
FEED using the E rings.
5)
Attach COVER FEED to HOUSING ASSY FEED.
6)
Fix COVER FEED to HOUSING ASSY FEED using two screws (silver, tap, 8mm).
7)
Attach HOUSING ASSY FEED. (RRP 3.14)
8)
Attach DRIVE ASSY FEED 250. (RRP 3.5)
9)
Attach CLUTCH ASSY PH. (RRP 3.7)
10) Attach 250 SHEET FEEDER LEFT COVER. (RRP 3.2)
11) Attach 250 SHEET PAPER TRAY. (RRP 2.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 99
Advertisement
Chapters
Table of Contents
