Table of Contents
Advertisement
RRP4.11 MULTIPURPOSE ROLLER ASSEMBLY (PL 4.1.24)
[Replacement]
When carrying out the work shown below, PAPER GUIDE (PL 4.1.25) must be attached
in a way that its paper holding section is facing down.
1)
After inserting the left side of the shaft section of MULTIPURPOSE ROLLER ASSEMBLY
(PL 4.1.24) into the bearing section on the left side of KIT-MULTIPURPOSE FEEDER
ASSEMBLY (PL 4.1.1), shift MULTIPURPOSE ROLLER ASSEMBLY to the right and attach
MULTIPURPOSE ROLLER ASSEMBLY.
2)
Match the notch of left and right BEARING MSI (PL 4.1.2) on MULTIPURPOSE ROLLER
ASSEMBLY to the positioning pin of SHAFT ASSY MSI, then fix MULTIPURPOSE ROLLER
ASSEMBLY by inserting BEARING MSI into left and right bearing of MULTIPURPOSE
FEEDER ASSEMBLY.
3)
Match the notch of left and right CAM PICK UP MSI (PL 4.1.3) on MULTIPURPOSE
ROLLER ASSEMBLY to the positioning pin of SHAFT ASSY MSI, then shift left and right
CAM PICK UP MSI outward.
Make sure to match the notch of CAM PICK UP MSI to the positioning pin of
MULTIPURPOSE ROLLER ASSEMBLY without fail.
4)
Fix left and right CAM PICK UP MSI to SHAFT ASSY MSI using E rings.
When carrying out the work shown below, turn MULTIPURPOSE ROLLER ASSEMBLY
to release CAM PICK UP MSI and raise PLATE BOTTOM ASSY MSI. This help carry out
the work more easily.
When carrying out the work shown below, pay attention to the orientation of SPRING-N/F
MSI to be attached.
Attach the oblong side at the attaching section of SPRING-N/F MSI to BEARING MSI.
Attach half circle side at the attaching section of SPRING-N/F MSI to PLATE BOTTOM
ASSY MSI.
5)
Attach the oval fitting part of SPRING-N/F MSI to BEARING MSI.
6)
Attach the semicirle fitting part of SPRING-N/F MSI to PLATE BOTTOM ASSY MSI.
7)
Attach SPRING-N/F MSI (PL 4.1.17) to the left and right sides of BEARING MSI.
8)
Attach SOLENOID PICK UP. (RRP 4.8)
9)
Attach MULTIPURPOSE FEEDER ASSEMBLY. (RRP 4.1)
10) Attach VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
11) Attach LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
12) Attach MULTIPURPOSE FEEDER COVER. (RRP 1.7)
13) Attach LEFT COVER. (RRP 1.10)
14) Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 152
Advertisement
Chapters
Table of Contents
