Table of Contents
Advertisement
RRP1.4
FUSER COVER (PL 1.1.6)
[Removal]
1)
Open FUSER COVER (PL 1.1.6).
2)
Pull out the boss of RIGHT COVER from the hole in FUSER COVER while spreading RIGHT
COVER (PL 1.1.8) and remove FUSER COVER.
[Replacement]
When carrying out the work shown below, securely fit the projections on FUSER COVER
right and left respectively inside RIGHT COVER and LEFT COVER.
1)
With the FUSER COVER (PL 1.1.6) opened state, engage the left side hole in FUSER COVER
with the boss of LEFT COVER (PL 1.1.16), and then, spread RIGHT COVER and insert the
boss of RIGHT COVER in the right side hole in FUSER COVER to attach it.
2)
Close FUSER COVER.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 23
Advertisement
Chapters
Table of Contents
