Table of Contents
Advertisement
RRP9.5
PHOTO SENSOR (PL 9.1.12)
[Removal]
1)
Remove LEFT COVER. (RRP 1.10)
2)
Remove LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
3)
Remove a screw (silver, with a flange, 6mm) that fixes BRACKET SENSOR (PL 9.1.13) to the
main unit.
4)
Remove BRACKET SENSOR from the main unit together with PHOTO SENSOR (PL 9.1.12).
5)
Remove connector (P/J105) of PHOTO SENSOR.
6)
Release the hooks at three locations that fix PHOTO SENSOR to BRACKET SENSOR and
remove PHOTO SENSOR.
[Replacement]
1)
Match three hooks of PHOTO SENSOR to fitting position and attach it to BRACKET
SENSOR.
2)
Attach connector (P/J105) of PHOTO SENSOR.
3)
Match hole of BRACKET SENSOR to the boss of the main unit and attach BRACKET
SENSOR together with PHOTO SENSOR.
4)
Fix BRACKET SENSOR to main unit using a screw (silver, with a flange, 6mm).
5)
Attach LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
6)
Attach LEFT COVER. (RRP 1.10)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 245
Advertisement
Chapters
Table of Contents
