Table of Contents
Advertisement
RRP10.1 FUSER (PL 10.1.1)
FUSER part is very hot, so pay sufficient attention at work to avoid burns, etc.
[Removal]
1)
Open FUSER COVER (PL 1.1.6).
2)
Raise levers on both sides of FUSER (PL 10.1.1) to release lock and remove FUSER.
[Replacement]
1)
Match connector and boss part on FUSER side to connector and hole on main unit side and
attach FUSER.
2)
Return levers on both sides of FUSER and lock it to the main unit properly.
3)
Close FUSER COVER.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 259
Advertisement
Chapters
Table of Contents
