Table of Contents
Advertisement
RRP7.5
BCR CLEANING ASSEMBLY (PL 7.1.19)
[Removal]
1)
Remove COVER ASSY RH. (RRP 1.12)
2)
Remove VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
When carrying out the work shown below, leave the relay connector on the harness side.
3)
Remove the connector (P/J617) of BCR CLEANING ASSEMBLY (PL 7.1.19) at the right side
of the main unit.
4)
Release a clamp on right side of the main unit and move the harness of BCR CLEANING
ASSEMBLY towards the inside of the main unit from the hole at right side of the main unit.
When carrying out the work shown below, push LATCH ROTARY (PL 9.1.3) of
DEVELOPER LATCH ASSEMBLY (PL 9.1.1) to release the latch, turn DEVELOPER
ROTOR FRAME ASSEMBLY(PL 9.2.9) manually, move HOUSING ASSY-DEVE, and
avoid your hand or arm being stained by the toner of MAG ROLL.
5)
Remove two screws (silver, with a flange, 6mm) that fix BCR CLEANING ASSEMBLY to the
main unit.
6)
Remove BCR CLEANING ASSEMBLY from the main unit.
[Replacement]
1)
Match the boss of BCR CLEANING ASSEMBLY to the hole in the main unit and attach it.
When carrying out the work shown below, push LATCH ROTARY (PL 9.1.3) of
DEVELOPER LATCH ASSEMBLY (PL 9.1.1) to release the latch, turn DEVELOPER
ROTOR FRAME ASSEMBLY(PL 9.2.9) manually, move HOUSING ASSY-DEVE, and
avoid your hand or arm being stained by the toner of MAG ROLL.
2)
Fix BCR CLEANING ASSEMBLY to the main unit using the two screws (silver, with a flange,
6mm).
3)
Move the harness of BCR CLEANING ASSEMBLY to outside through the hole on right side of
the main unit and attach connector (P/L 617) of BCR CLEANING ASSEMBLY.
4)
Fix the harness of BCR CLEANING ASSEMBLY on the right side of the main unit using a
clamp.
5)
Attach VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
6)
Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 229
Advertisement
Chapters
Table of Contents
