Table of Contents
Advertisement
RRP12.10 CHASSIS ASSY ESS (REFERENCE ONLY)
[Removal]
1)
Remove LEFT COVER. (RRP 1.10)
2)
Remove the connector (P/J129 and P/J700), the connector (P/J701) and the connector (P/J702)
on ELECTRONIC SUB SYSTEM(ESS) CONTROLLER BOARD(PL 12.2.2).
3)
Take out removed the connectors from the holes in CHASSIS A (PL 12.2.1).
4)
Release the clamp on CHASSIS A and remove the harness on CHASSIS ASSY ESS.
5)
Remove the five screws (silver, with a flange, 6mm) that fix CHASSIS ASSY ESS to the main
unit.
6)
Remove CHASSIS ASSY ESS from the main unit.
[Replacement]
The harness should not be caught between the main unit and CHASSIS A when carrying
out the work shown below.
1)
Match the convex of CHASSIS ASSY ESS to the hole of the main unit, attach CHASSIS ASSY
ESS.
2)
Fix CHASSIS ASSY ESS to the main unit using the five screws (silver, with a flange, 6mm).
3)
Insert removed the connectors through the holes in CHASSIS A.
4)
Attach the connector (P/J129 and P/J700), the connector (P/J701) and the connector (P/J702)
on PWBA ESS.
5)
Fix the harness using the clamp on CHASSIS ASSY ESS.
6)
Attach LEFT COVER. (RRP 1.10)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 293
Advertisement
Chapters
Table of Contents
