Dell 3010CN Service Manual page 221

RRP4.1 MULTIPURPOSE FEEDER ASSEMBLY (PL 4.1.1)
[Replacement]
When carrying out the work shown below, take care not to allow the cable tie which
bundles the harness of HARNESS-ASSY P/H 1 to be caught in the hole or the like in the
main body.
Be sure that harness of HARNESS-ASSY P/H 1 is not caught between the main unit and
MULTIPURPOSE FEEDER ASSEMBLY when carrying out the work shown below.
1)Lay the harness of HARNESS -ASSY P/H 1 (PL 4.1.23) along the left side of
MULTIPURPOSE FEEDER ASSEMBLY (PL 4.1.1), put it together with MULTIPURPOSE
FEEDER ASSEMBLY in the front of main unit.
2) Put MULTIPURPOSE FEEDER ASSEMBLY in the main unit by half with its front part
slightly raised taking care to avoid TIE PLATE at the bottom of the main unit. Then, draw out
the connector of HARNESS-ASSY P/H 1 through the hole in the main unit.
3) Align the MULTIPURPOSE FEEDER ASSEMBLY with its mounting position in the main
unit. Then pull the HARNESS-ASSY P/H 1 slowly from outside taking care not to allow it to
loosen inside the main unit.
4) Fix MULTIPURPOSE FEEDER ASSEMBLY to the main unit using six screws (silver, with a
flange, tap, 8mm).
5) Attach connector (P/J408) and connector (P/J409) on MACHINE CONTROL UNIT(MCU)(PL
12.2.4).
6) Fix the harness of HARNESS-ASSY P/H 1 using the two clamps located at the CHASSIS A
(PL 12.2.1).
7) Attach VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
8) Attach LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
9) Attach MULTIPURPOSE FEEDER COVER. (RRP 1.7)
10) Attach LEFT COVER. (RRP 1.10)
11) Attach COVER ASSY RH. (RRP 1.12)
12) Attach OPTION PAPER FEEDER ASSY for OPTION PAPER FEEDER specification. (RRP
3.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 123