Warm-Up Time; Fpot (First Print Output Time) - Dell 3110cn Service Manual

4.7 Warm-up Time

When nominal voltage (100V, 115V, 220V) is applied, the printer will proceed to standby mode from
POWER-ON within 30 seconds.
Reference: Measured at 22°C, 55% RH, nominal voltage.

4.8 FPOT (First Print Output Time)

FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the PRINT indication is given is
calculated on the following conditions (rounded to one decimal place).
• IOT performance that the controller does not have IOT wait.
• The printer is in the standby mode. (ROS MOTOR OFF, FUSER READY)
• Paper is A4 SEF
• Except when process control is operating*1
*1:Process controller operation is process controls such as TC control, electric potential control,
cleaning cycle, registration control, and so on. Sometimes, the engine stops feeding papers for
a certain period of time while continuous printing for these operations.
Color Mode
B/W
Color
Version 1 2006.02.02
Paper Tray
MPF
Standard tray
Optional 2nd tray
MPF
Standard tray
Optional 2nd tray
FPOT (Sec.)
7.6 sec. or less
7.5 sec. or less
8.1 sec. or less
8.4 sec. or less
8.3 sec. or less
8.9 sec. or less
8 – 9
Chapter 8 Printer Specifications