Removal And Replacement Procedures (Rrps); Before Starting Service Work - Dell 3010CN Service Manual

1. Removal and Replacement Procedures (RRPs)

Removal and replacement procedures for main parts of the device are described using 15 broad
categories that correspond to the parts list.
∗RRP 1
∗RRP 2
∗RRP 3
∗RRP 4
∗RRP 5
∗RRP 6
∗RRP 7
*RRP 8
∗RRP 9
∗RRP 10
∗RRP 11
∗RRP 12
∗RRP 14
∗RRP 15
When working for parts that are controlled as spare parts but no procedure is included,
observe the replacement status of the parts thoroughly before starting the work.
Refer to the manuals of optional parts for optional parts.
Optional parts are supposed to be removed as a basic rule, however, if it is not necessary
to remove tflange, it is acceptable to work with tflange attached.

1.1 Before starting service work

Start the work after turning off the power and removing the power cord from the outlet.
Disassemble the device after removing IBT (PL 7.1.1).
When carrying out the work around FUSER, temperature of FUSER and surrounding area
should have cooled sufficiently.
Pay sufficient attention to the parts during work because they may be broken or may not
perform their functions properly if unreasonable force is applied to tflange.
COVER
250 PAPER CASSETTE
250 PAPER FEEDER
MSI
PH ASSY
TRANSFER
XERO
ROS
DEVE
FUSER
DRIVE
ELECTRICAL
500 PAPER CASSETTE & 500 PAPER FEEDER
LEGAL PAPER CASSETTE
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 1