Table of Contents
Advertisement
RRP1.11 FUSER COVER INTERLOCK (PL 1.1.17)
[Removal]
1)
Remove LEFT COVER. (RRP 1.10)
2)
Release the harness clamp that fixes the harness of FUSER COVER INTERLOCK (PL 1.1.17)
and remove it.
3)
Remove a screw (silver, with flange, 8mm) that fixes the FUSER COVER INTERLOCK and
the BRACKET COVER TOP A LH (PL1.1.35) to the printer.
4)
Remove the FUSER COVER INTERLOCK and the BRACKET COVER TOP A LH from the
printer.
When carrying out the work shown below, leave the relay connector on the harness side.
5)
Remove connector (P/J114) and connector (P/J117) of FUSER COVER INTERLOCK.
[Replacement]
1)
Attach connector (P/J114) and connector (P/J117) of FUSER COVER INTERLOCK.
2)
Match the hole in FUSER COVER INTERLOCK to the boss of the main unit and attach it.
3)
Match the boss of the BRACKET COVER TOP A LH to the hole of the FUSER COVER
INTERLOCK, attach the BRACKET COVER TOP A LH.
4)
Attach the FUSER COVER INTERLOCK and the BRACKET COVER TOP A LH to the
printer using a screw (silver, with flange, 8mm).
5)
Fix the harness of FUSER COVER INTERLOCK on the harness clamp.
6)
Attach LEFT COVER. (RRP 1.10)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 37
Advertisement
Chapters
Table of Contents
