Table of Contents
Advertisement
RRP9.8
COVER ROTARY BOTTOM (PL 9.2.13)
[Removal]
1)
Remove COVER ASSY RH. (RRP 1.12)
2)
Remove TOP COVER. (RRP 1.1)
3)
Remove LEFT COVER. (RRP 1.10)
4)
Remove MULTIPURPOSE FEEDER COVER. (RRP 1.7)
5)
Remove LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
6)
Remove COVER INNER L. (RRP 1.13)
7)
Remove PWBA MCU. (RRP 12.6)
8)
Remove LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
9)
Remove CHASSIS ASSY ESS. (RRP 12.10)
10) Remove LEFT IBT GUIDE ASSEMBLY. (RRP 7.2)
11) Remove RIGHT IBT GUIDE ASSEMBLY. (RRP 7.4)
12) Remove IBT CLEANING DRIVE ASSEMBLY. (RRP 11.2)
13) Remove DEVELOPMENT MOTOR. (RRP 11.5)
14) Remove PHOTORECEPTOR MOTOR. (RRP 11.6)
15) Remove DEVELOPER LATCH ASSEMBLY. (RRP 9.1)
16) Remove TONER CARTRIDGE SENSOR. (RRP 9.2)
17) Remove HOLDER ASSY-BIAS. (RRP 9.4)
18) Remove PHOTO SENSOR. (RRP 9.5)
19) Remove HOUSING ASSY-DEVE. (RRP 9.6)
20) Remove FRAME ASSY-ROTARY. (RRP 9.7)
21) Remove DEVELOPER ROTOR MOTOR. (RRP 11.4)
22) Remove HIGH VOLTAGE POWER SUPPLY(HVPS). (RRP 12.1)
23) Remove ROTOR CONTROL BOARD. (RRP 12.2)
24) Remove PWBA CRUM. (RRP 12.4)
25) Remove WIRE ASSY DEVE (PL 9.1.14) from COVER ROTARY BOTTOM (PL 9.2.13).
26) Remove the two screws (silver, with a flange, 10mm) that fix COVER ROTARY BOTTOM to
the main unit.
27) Slide COVER ROTARY BOTTOM backward, release the left and right hooks of COVER
ROTARY BOTTOM from the main unit, and remove COVER ROTARY BOTTOM.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 255
Advertisement
Chapters
Table of Contents
