Table of Contents
Advertisement
RRP6.12 IBT CAM ASSEMBLY (PL 6.1.24)
[Removal]
1)
Remove COVER ASSY RH. (RRP 1.12)
2)
Remove LEFT COVER. (RRP 1.10)
3)
Remove COVER INNER U. (RRP 1.14)
4)
Remove PWBA MCU. (RRP 12.6)
It is not necessary to remove PHOTO SENSOR: IBT RETRACT (PL 6.1.19) from
BRACKET-SENSOR CLN (PL 6.1.37) when carrying out the work shown below.
5)
Remove PHOTO SENSOR: IBT RETRACT. (RRP 6.10)
6)
Remove the right and left E rings that fix IBT CAM ASSEMBLY (PL 6.1.24) to the main unit.
7)
Remove the right and left BEARING-BRUSH CAM (PL 6.1.9) that fix IBT CAM ASSEMBLY
to the main unit.
8)
Move IBT CAM ASSEMBLY to left side once, pull out the shaft of IBT CAM ASSEMBLY from
the right bearing of the main unit and remove IBT CAM ASSEMBLY.
[Replacement]
1)
After placing the left side shaft of IBT CAM ASSEMBLY in the left side bearing of the main
unit, move IBT CAM ASSEMBLY to the right side and attach IBT CAM ASSEMBLY.
2)
Fix IBT CAM ASSEMBLY to the main unit using the right and left BEARING-BRUSH CAMs.
3)
Fix IBT CAM ASSEMBLY to the main unit using right and left E rings.
4)
Attach PHOTO SENSOR: IBT RETRACT. (RRP 6.10)
Check that shutter of IBT CAM ASSEMBLY is placed in the sensing section of PHOTO
SENSOR.
5)
Attach PWBA MCU. (RRP 12.6)
6)
Attach COVER INNER U. (RRP 1.14)
7)
Attach LEFT COVER. (RRP 1.10)
8)
Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 211
Advertisement
Chapters
Table of Contents
