Table of Contents
Advertisement
IrDA Interface
Outline of IrDA Interface
Each channel of the serial interface contains a PPM modulator circuit, allowing an infrared-ray communication
circuit to be configured based on IrDA 1.0 simply by adding a simple external circuit.
S1C33
Serial I/F
This IrDA interface function can be used only when the selected transfer mode is an asynchronous mode.
Since the contents of the asynchronous mode are applied directly for the serial-interface functions other than the
IrDA interface unit, refer to "Asynchronous Interface", for details on how to set and control the data formats and
data transfers.
Setting IrDA Interface
When performing infrared-ray communication, the following settings must be made before communication can be
started:
1. Setting input/output pins
2. Selecting the interface mode (IrDA interface function)
3. Setting the transfer mode
4. Setting the input clock
5. Setting the data format
6. Setting the interrupt/IDMA/HSDMA
7. Setting the input/output logic
The contents for items 1 through 5 have been explained in connection with the asynchronous interface. For details,
refer to "Asynchronous Interface". For details on item 6, refer to "Serial Interface Interrupts and DMA".
Note: Before making these settings, always make sure the serial interface is inactive (TXENx and
RXENx are both set to "0"), as a change in settings during operation could cause a malfunction.
In addition, be sure to set the transfer mode in (3) and the following items before selecting the
IrDA interface function in (2).
S1C33L03 FUNCTION PART
SOUTx
PPM
Modulator
SINx
PPM
Modulator
V
DD
V
SS
Figure 8.14 Configuration Example of IrDA Interface
EPSON
III PERIPHERAL BLOCK: SERIAL INTERFACE
Infrared communication module
LED A
LED
TXD
LED C
Photodiode
RXD
CX1
Vcc
CX2
V
P1N
GND
(Example: HP HSDL-1000)
A-1
V
P1N
B-III
SIF
B-III-8-21
Advertisement
Table of Contents
