Configure Static Routes For The Management Interface; Ipv4 Path Mtu Discovery Overview - Dell S4048T Configuration Manual

S 6.1.2.17/32 via 6.1.20.2, Te 5/1
S 11.1.1.0/24 Direct, Nu 0
Direct, Lo 0
--More--
Dell Networking OS installs a next hop that is on the directly connected subnet of current IP address on the
interface.
Dell Networking OS also installs a next hop that is not on the directly connected subnet but which recursively
resolves to a next hop on the interface's configured subnet.
• When the interface goes down, Dell Networking OS withdraws the route.
• When the interface comes up, Dell Networking OS re-installs the route.
• When the recursive resolution is "broken," Dell Networking OS withdraws the route.
• When the recursive resolution is satisfied, Dell Networking OS re-installs the route.
Configure Static Routes for the
Management Interface
When an IP address that a protocol uses and a static management route exists for the same prefix, the
protocol route takes precedence over the static management route.
To configure a static route for the management port, use the following command.
• Assign a static route to point to the management interface or forwarding router.
CONFIGURATION mode
management route ip-address mask {forwarding-router-address | ManagementEthernet
slot/port}
Example of the show ip management-route Command
To view the configured static routes for the management port, use the show ip management-route
command in EXEC privilege mode.
Dell#show ip management-route
Destination
-----------
10.16.0.0/16
172.16.1.0/24

IPv4 Path MTU Discovery Overview

The size of the packet that can be sent across each hop in the network path without being fragmented is
called the path maximum transmission unit (PMTU). This value might vary for the same route between two
devices, mainly over a public network, depending on the network load and speed, and it is not a consistent
value. The MTU size can also be different for various types of traffic sent from one host to the same endpoint.
Path MTU discovery (PMTD) identifies the path MTU value between the sender and the receiver, and uses the
determined value to transmit packets across the network. PMTD, as described in RFC 1191, denotes that the
Gateway
-------
ManagementEthernet 1/1
10.16.151.4
1/0 00:02:30
0/0 00:02:30
State Route Source
----- ------------
Connected Connected
Active Static
IPv4 Routing 501