Resetting An Interface To Its Factory Default State; Enabling A Physical Interface - Dell S4048T Configuration Manual

Resetting an Interface to its Factory
Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration,
perform the following steps:
1 View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.

Enabling a Physical Interface

After determining the type of physical interfaces available, to enable and configure the interfaces, enter
INTERFACE mode by using the interface interface command.
1 Enter the keyword interface then the type of interface and slot/port[/subport] information.
CONFIGURATION mode
Interfaces 455