Enable A Physical Interface - Dell Force10 Z9000 Configuration Manual

Figure 19-3. Interfaces listed in the show running-config Command (Partial)
FTOS#show running
Current Configuration ...
!
interface GigabitEthernet 9/6
no ip address
shutdown
!
interface GigabitEthernet 9/7
no ip address
shutdown
!
interface GigabitEthernet 9/8
no ip address
shutdown
!
interface GigabitEthernet 9/9
no ip address
shutdown

Enable a Physical Interface

After determining the type of physical interfaces available, the user may enter the INTERFACE mode by
entering the command
To enter the INTERFACE mode, use these commands in the following sequence, starting in the
CONFIGURATION mode:
Step Command Syntax
1 interface interface
2 no shutdown
| Interfaces
376
interface interface slot/port
Command Mode
CONFIGURATION
INTERFACE
to enable and configure the interfaces.
Purpose
Enter the keyword interface followed by the type of interface
and slot/port information:
• For a 10/100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface on the RPM, enter the
keyword ManagementEthernet followed by the slot/
port information.
For a SONET interface, enter the keyword sonet followed
•
by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
Enter the no shutdown command to enable the interface. If
the interface is a SONET interface, enter the encap ppp
command to enable PPP encapsulation.