Milltronics Md-36 Speed Sensor; The Manual - Siemens Milltronics MD-36 Instruction Manual

Milltronics MD-36 Speed Sensor

The Milltronics MD-36 is a general purpose and hazardous rated speed sensor. The
sensor, coupled to the motor or pulley shaft, converts the rotation of its input shaft into an
encoded speed signal. The speed signal is transmitted to the integrating electronics for
use in calculating the rate of material flow.
Siemens Milltronics provides a full range of electronic integrators:
• Compuscale III
The MD-36 sensors can also be used with older model Siemens Milltronics integrators:
• Compuscale
• Compuscale II
For further information about Siemens Milltronics products,
go to www.siemens-milltronics.com.

The Manual

Notes
• Please follow the installation and operating procedures for a quick, trouble-free
installation and to ensure the maximum accuracy and reliability of your Siemens
Milltronics weighing system.
• This manual applies to the MD-36 Speed Sensors only. Please consult the
separate integrator and belt scale manuals for operating instructions.
This manual will help you set up your MD-36 Speed Sensor for optimum performance. We
always welcome suggestions and comments about manual content, design, and
accessibility.
Please direct your comments to techpubs@siemens-milltronics.com.
Page 4 Milltronics MD-36 Speed Sensor – INSTRUCTION MANUAL
• Milltronics BW 100 • Milltronics BW 500
• Compuscale IIA
• Compu-M
7ML19985DB01