Extreme Networks ExtremeWare Command Reference Manual page 1321

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

T1, E1, and T3 WAN Commands

This chapter describes the following commands:

• Commands for configuring T1, E1, and T3 WAN links.

• Point-to-Point Protocol (PPP) and Multilink PPP (MLPPP) commands for WAN links.

• Commands to display and monitor WAN links.

Extreme Networks WAN modules allow you to pass Ethernet traffic over technologies originally

developed for telecommunications. T1, E1, and T3 links have all been used to pass voice traffic over

telecommunications networks for many years. Now you can pass data traffic with these modules

developed specifically for the Extreme Networks Alpine 3800 family of switches.

To pass data traffic over these modules, the traditional T1, E1, or T3 parameters are configured, and

then PPP is used to pass the Ethernet data across the link.

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0