Enable Aps - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

enable aps

Enables the APS function for an entire switch.

Syntax Description

This command has no arguments or variables.

APS is disabled by default.

Usage Guidelines

If APS is enabled, interfaces configured as protection lines can carry traffic.

To enable the APS function for the entire switch, use the following command:

This command was first available in an ExtremeWare IP Technology Services Release based on

Platform Availability

This command is available on the BlackDiamond switch only.

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0