Create Bgp Neighbor Peer-Group - Extreme Networks ExtremeWare Command Reference Manual

create bgp neighbor peer-group

create bgp neighbor <ip address> peer-group <peer group> {multi-hop}
Description
Creates a new neighbor and makes it part of the peer group.
Syntax Description
ip address
peer group
multi-hop
Default
N/A.
Usage Guidelines
All the parameters of the neighbor are inherited from the peer group. The peer group should have the
remote AS configured.
To add an existing neighbor to a peer group, use the following command:
config bgp neighbor [<ip address> | all] peer-group <peer group> {acquire-all}
If you do not specify acquire-all, only the mandatory parameters are inherited from the peer group. If
you specify acquire-all, all of the parameters of the peer group are inherited. This command disables the
neighbor before adding it to the peer group.
Example
The following command creates a new neighbor and makes it part of the peer group external:
create bgp neighbor 192.1.1.22 peer-group external
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all "i" series platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies an IP address.
Specifies a peer group.
Specifies to allow connections to EBGP peers that are not directly connected.
create bgp neighbor peer-group
1091