Config Vlan Add Track-Lsp - Extreme Networks ExtremeWare Command Reference Manual
Version 7.0.0
Hide thumbs
Also See for ExtremeWare:
- Command reference manual (2620 pages) ,
- Command reference manual (2546 pages) ,
- Command reference manual (2254 pages)
Table of Contents
Advertisement
MPLS Commands
config vlan add track-lsp
config vlan <vlan name> add track-lsp [<lsp_name> | ipaddress
<ipaddress>/<masklength>]
Description
Configures the LSPs tracked by ESRP in order to determine the ESRP state of the specified VLAN.
Syntax Description
vlan name
lsp_name
ipaddress
Default
No diagnostic tracking.
Usage Guidelines
LSP tracking provides MPLS with specific ESRP selection criteria for determining the ESRP status of a
VLAN. LSP tracking is similar to route tracking and ping tracking in ESRP. ESRP can be configured to
protect the user VLAN from disruptions in the MPLS network core.
This type of LSP protection is especially useful when providing ESRP redundant TLS L2 VPN services
using Traffic Engineered LSPs that take completely different paths.
Using ESRP domains, LSP tracking can be easily scaled to support several TLS VLANs that are tunneled
across an L2 VPN using a single LSP. Instead of each TLS VLAN tracking the same LSP, all of the TLS
VLANs are placed into an ESRP domain for which there is one non-TLS VLAN, configured to track the
state of the LSP. When ESRP detects that the LSP has failed, all of the VLANs in the configured ESRP
domain transition to neutral state and the backup LSR becomes the master switch for all of the TLS
VLANs.
The
command configures ESRP to track up to eight LSPs. Fail over to the slave switch
add track-lsp
is based on the total number of established tracked LSPs. The switch with the greatest number of
established tracked LSPs is elected the master switch for the specified VLAN. Specifying the parameter
<
instructs ESRP to track the status of an RSVP-TE LSP. Specifying the
lsp_name>
instructs ESRP to track the LSP status for the IP prefix as defined by the
parameter. Both types of LSPs can be tracked simultaneously.
Example
The following command enables LSP route failure tracking for routes to the specified subnet:
config vlan esrp-1 add track-lsp 192.168.46.0/24
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
1408
Specifies an ESRP-enabled VLAN name.
Specifies a LSP name.
Specifies the IP address of the route entry to be tracked.
keyword
ipaddress
<ipaddress/masklength>
ExtremeWare Software 7.0.0 Command Reference Guide
Advertisement
Table of Contents
