Enable Rip Aggregation - Extreme Networks ExtremeWare Command Reference Manual

IGP Commands

enable rip aggregation

enable rip aggregation
Description
Enables the RIP aggregation of subnet information on a RIP version 2 (RIPv2) interface.
Syntax Description
This command has no arguments or variables.
Default
Enabled.
Usage Guidelines
The enable (disable) rip aggregation command enables (disables) the RIP aggregation of subnet
information on an interface configured to send RIPv1 or RIPv2-compatible traffic. The switch
summarizes subnet routes to the nearest class network route. The following rules apply when using RIP
aggregation:
• Subnet routes are aggregated to the nearest class network route when crossing a class boundary.
• Within a class boundary, no routes are aggregated.
• If aggregation is enabled, the behavior is the same as in RIPv1.
• If aggregation is disabled, subnet routes are never aggregated, even when crossing a class boundary.
Example
The following command enables RIP aggregation on the interface:
enable rip aggregation
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
1004 ExtremeWare Software 7.0.0 Command Reference Guide