Extreme Networks ExtremeWare Command Reference Manual page 1380

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

MPLS Commands

route-map <route_map>

unsolicited label mappings for all routes of the specified type.

The only supported route map match operation keyword is

parameter of the

access_profile

with each route.

For more information on route maps, see the ExtremeWare Software Users Guide.

RIP routes are advertised with the Implicit NULL label and direct routes are advertised with an MPLS

label, unless PHP is enabled.

Advertising labels for a large number of routes may increase the required number of labels that must be

allocated by LSRs. Take care to ensure that the number of labels advertised by LERs does not

overwhelm the label capacity of the LSRs.

The following command configures a filter to be used by LDP when originating unsolicited label

mapping advertisements for RIP routes:

config mpls ldp advertise rip all

This command was first available in an ExtremeWare IP Technology Services Release based on

This command was subsequently incorporated into ExtremeWare 7.0.0.

Platform Availability

This command is available on the BlackDiamond switch only.

—The specified route map is used to permit or deny the origination of

keyword is compared to the FEC that is associated

. If selected, the

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0