Config Debug-Trace Pim-Message - Extreme Networks ExtremeWare Command Reference Manual

config debug-trace pim-message

config debug-trace pim-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
debug level
vlan name
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
This command traces all PIM system messages (join, prune, graft, graft acknowledgement, and assert
for PIM-DM, and join, prune, assert, register, and register-top for PIM-SM) coming into a VLAN. Use
this command if a multicast stream cannot be stopped or does not come down to the receiver after the
IGMP snooping entry is verified, or if the CPU load is unexpectedly high.
Example
The following command sets the reporting level for PIM message errors to 3:
config debug-trace pim-message 3
Following is the log output at this level:
<INFO:SYST> msm-a-console admin: configure debug-trace pim-message 3 vlan all
<DBUG:PIM> PIM: Xmitting RP Adv(8) pkt of len 22 from src 15.2.1.1 to 15.1.6.3
<DBUG:PIM> PIM: Xmitting RP Adv(8) pkt of len 22 from src 15.1.6.1 to 15.1.6.3
<DBUG:PIM> PIM: Xmitting RP Adv(8) pkt of len 22 from src 15.1.4.1 to 15.1.6.3
<DBUG:PIM> PIM: ProcPrune: src 0.0.0.0 rp 15.1.4.1 type (*,g)
<DBUG:PIM> PIM: ProcJoinPrune: joins 0 prunes 1
<DBUG:PIM> PIM: ProcJPG: handling 235.1.1.201/255.255.255.255
<DBUG:PIM> PIM: ProcJPG: una=15.1.4.1 peerRtr=0 hold_time=210 #grp=1
<DBUG:PIM> PIM: Receiving Join/Prune(3) pkt of len 34 from src 15.1.4.2 to dst
224.0.0.13 thro 15.1.4.1
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies a debug level:
0 — Records error messages.
1 — Records warnings.
2 — Records verbose warnings.
3 — Displays a dump of each packet.
4 — No additional information recorded.
5 — No additional information recorded.
Specifies a VLAN name.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
config debug-trace pim-message
1535