Config Stpd Hellotime - Extreme Networks ExtremeWare Command Reference Manual

config stpd hellotime

config stpd <spanning tree name> hellotime <seconds>
Description
Specifies the time delay (in seconds) between the transmission of Bridge Protocol Data Units (BPDUs)
from this STPD when it is the Root Bridge.
Syntax Description
spanning tree name
seconds
Default
2 seconds.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
Example
The following command sets the time delay from STPD1 to 10 seconds:
config stpd stpd1 hellotime 10
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies an STPD name on the switch.
Specifies the hello time in seconds.
parameter is 1 through 10 seconds.
<seconds>
config stpd hellotime
707