Extreme Networks ExtremeWare Command Reference Manual page 1391

hold-priority
does not support LSP preemption.
The
retry-timeout
setup. If the LSP cannot be established within
default value for
parameter limits the number of LSRs the path can traverse, including the ingress and egress
hop-count
router. The default
After an LSP has established, the egress LSR may be optionally pinged to determine end-to-end path
connectivity. If a ping response is not received within [2 *
considered unavailable. The
transmitted to the egress LSR IP address on the established LSP. The default
which indicates no end-to-end LSP health checking is performed. You can set the
to any interval between 0 and 60 seconds.
The route
metric
data. Whenever the configured metric is less than, or equal, to the calculated IGP metric, the LSP is
used for sending routed IP traffic. In this case, the LSP is also used to send TLS data when the TLS
tunnel is configured by specifying the tunnel LSP endpoint IP address. Traffic is distributed across up
to four equal-cost LSPs. The valid metric values range from 1 to 65535. Specifying the
keyword forces the route metric to track the underlying IGP metrics. If no IGP metric exists for the LSP
(for example, the LSP traverses a RIP network), the metric is ignored. Tracking IGP metrics is the
default behavior.
The
record
record route object (RRO) to be inserted into the path message. The RRO is returned in the reserve
message and contains a list of IPv4 subobjects that describe the RSVP-TE path. Path recording by
default is disabled. When disabled, no RRO is inserted into the path message.
Example
The following command adds a profile with the configured attributes:
• Reserved bandwidth signaled is 100 Mbps
• Tunnel LSP setup priority is 1
• Tunnel LSP hold priority is 0
• Route recording is enabled
config mpls rsvp-te add profile customer1 bandwidth 100m setup-priority 1
hold-priority 0 record enabled
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
ExtremeWare Software 7.0.0 Command Reference Guide
range is also 0 to 7 and is set equal to the
keyword specifies the maximum number of seconds the switch allows for LSP
is 30 seconds with a configurable range of 5 to 600 seconds. The
retry-timeout
value is 255 with a configurable range of two to 255.
hop-count
ping-interval
is used to determine if an established RSVP-TE LSP will actually be used to send
keyword is used to enable hop-by-hop path recording. The enabled keyword causes the
setup-priority
seconds, the LSP is resignaled. The
retry-timeout
ping-interval
keyword specifies how frequently an ICMP echo request is
config mpls rsvp-te add profile
by default. ExtremeWare
– 1] seconds, the LSP is
is zero,
ping-interval
value
ping-interval
igp-tracking
1391