Enable Ports T1 Loopback Network Payload - Extreme Networks ExtremeWare Command Reference Manual

T1, E1, and T3 WAN Commands

enable ports t1 loopback network payload

enable ports <portlist> t1 loopback network payload
Description
Enables network payload loopback mode on T1 links.
Syntax Description
portlist A list of ports.
Default
Loopback is disabled by default.
Usage Guidelines
Use this command to enable network payload loopback modes on the local port for T1 links. This mode
is not available for E1 and T3 links.
WAN links also support additional modes, local and network line loopback. Use the following
command for these modes:
[local | network line]
enable ports <portlist> [t1 | e1 | t3] loopback
For remote loopback modes, use the command:
enable ports <portlist> [t1 | t3] loopback remote [line | payload | loopdown]
Example
The following command enables network payload loopback mode on a T1 link:
enable ports 4:3 t1 loopback network payload
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
1352 ExtremeWare Software 7.0.0 Command Reference Guide