Config Debug-Trace Stp-In-Pdu - Extreme Networks ExtremeWare Command Reference Manual

config debug-trace stp-in-pdu

config debug-trace stp-in-pdu <debug level> [mgmt | <slot number>]
Description
This command records debug information to the syslog.
Syntax Description
debug level
mgmt
slot number
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
If you do not specify a slot, messages for all slots are recorded.
Example
The following command sets the reporting level for STP in PDU errors to 4:
config debug-trace stp-in-pdu 4
Following is the log output at this level:
<DBUG:STP > Stpd s0 Port 3:11 Received Config Bpdu
<DBUG:STP > send_bpdu: s0 port 3:3, config
<DBUG:STP > Stpd s0 Port 3:11 Received Config Bpdu
<DBUG:STP > send_bpdu: s0 port 3:3, config
<INFO:SYST> msm-a-console admin: configure debug-trace stp-in-pdu 2
<DBUG:STP > last message repeated 3 times
<DBUG:STP > send_bpdu: s0 port 3:3, config
<DBUG:STP > last message repeated 51 times
<DBUG:STP > send_bpdu: s0 port 3:3, config
<DBUG:STP > last message repeated 51 times
<DBUG:STP > send_bpdu: s0 port 3:3, config
<INFO:SYST> Log cleared
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies a debug level:
0 — None.
1 — None.
2 — Records that port x:y received a config BPDU.
3 — No additional information recorded.
4 — Displays a dump of each BPDU.
5 — No additional information recorded.
Specifies the management port.
Specifies a slot number.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
config debug-trace stp-in-pdu
1547