Config Debug-Trace Bgp-Update-Out - Extreme Networks ExtremeWare Command Reference Manual

config debug-trace bgp-update-out

config debug-trace bgp-update-out <debug level>
Description
This command records debug information to the syslog.
Syntax Description
debug level
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
To limit the output to messages from a single neighbor, use the
command.
Example
The following command sets the reporting level for BGP update out errors to 3:
config debug-trace bgp-update-out 3
Following is the log output at this level:
<DBUG:BGP> Processing Int change entry 203.18.38.0/255.255.255.0
<DBUG:BGP> Processing Int change entry 198.58.1.0/255.255.255.0
<DBUG:BGP> Processing Int change entry 198.58.0.0/255.255.255.0
<DBUG:BGP> Processing Int change entry 192.251.195.0/255.255.255.0
<DBUG:BGP> Processing Int change entry 193.77.24.0/255.255.255.0
<DBUG:BGP> Qing Int Chg Blk for Rt 212.46.224.0 255.255.248.0.
<DBUG:BGP> Qing Ext Chg Blk for Rt 212.46.224.0 255.255.248.0.
<DBUG:BGP> Add dst 212.46.224.0/21 gw 10.10.30.10 cost 7
<DBUG:BGP> Deleting dst 212.46.224.0/21 gw 10.10.30.10 cost 6
<DBUG:BGP> Updating FDB for NLRI 212.46.224.0 255.255.248.0.
<DBUG:BGP> Qing Int Chg Blk for Rt 216.130.64.0 255.255.224.0.
<DBUG:BGP> Qing Ext Chg Blk for Rt 216.130.64.0 255.255.224.0.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies a debug level:
0 — None.
1 — None.
2 — Records transmitted BGP update messages with network prefix and peer IP
address information. Also records actions after the transmission including:
• Add transmitted routes to BGP neighbor advertised routing table.
3 — No additional information recorded.
4 — No additional information recorded.
5 — No additional information recorded.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
config debug-trace bgp-update-out
config debug-trace bgp-neighbor
1465