Show Multilink T1 Errors - Extreme Networks ExtremeWare Command Reference Manual

T1, E1, and T3 WAN Commands

show multilink t1 errors

show multilink <groupname> t1 errors [near-end | far-end] [totals |
intervals | current]
Description
Displays the current and past error statistics for T1 multilink groups.
Syntax Description
groupname
Default
N/A.
Usage Guidelines
For T1 multilink groups, you can display errors from the near-end or the far-end.
Display the total errors detected, errors detected per interval in the past, or errors detected in the
current interval.
For errors on E1 multilink groups, use the following command:
show multilink <groupname> e1 errors near-end [totals | intervals | current]
Example
The following command displays the T1 errors detected on the near-end during the current interval:
show ports t1 errors near-end current
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
T3 support was added in ExtremeWare v6.1.8w3.0.1b61 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
1360
Specifies a previously created multilink group
ExtremeWare Software 7.0.0 Command Reference Guide