Extreme Networks ExtremeWare Command Reference Manual page 1567

ipxsap-entry
ospf-hello
ospf-lsa
ospf-neighbor
ospf-spf
pim-cache
pim-hello
pim-neighbor
pim-message
pim-rp-mgmt
rip-message
rip-route-change
rip-triggered-update
slb-connection
slb-failover
slb-3dns
stp-in-pdu
stp-out-pdu
udp-forwarding
vlan name
Example
The following command displays the debug-trace levesl configured:
show debug-trace
Following is the output from this command:
OSPF SPF
Flowstats
Vlan
---------------------------------------------------------------------------
v49
Port Number
---------------------------------------------------------------------------
No port-based debug-tracing configured
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all "i" series platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Not currently supported.
Specifies OSPF hello level.
Specifies OSPF LSA level.
Specifies OSPF neighbor level.
Specifies OSPF SPF level.
Specifies PIM cache level.
Specifies PIM hello level.
Specifies PIM neighbor level.
Specifies PIM message level.
Specifies PIM RP level.
Specifies RIP message level.
Specifies RIP route level.
Specifies RIP triggered update level.
Specifies SLB connection level.
Specifies SLB failover level.
Specifies SLB 3DNS level.
Specifies incoming STP PDU level.
Specifies outgoing STP PDU level.
Not currently supported.
Specifies a VLAN name.
3
3
Debug
DVMRP route
Debug
Level
3
Level
show debug-trace
1567