Config Ppp Pos Checksum Ports - Extreme Networks ExtremeWare Command Reference Manual

PoS Commands

config ppp pos checksum ports

config ppp pos checksum [32 | 16] ports <portlist>
Description
Configures the size of the HDLC Frame Check Sequence (FCS) to be used on the specified SONET
ports.
Syntax Description
16 or 32
portlist
Default
The default is a 32-bit FCS.
Usage Guidelines
The two choices are a 32-bit FCS or a 16-bit FCS. RFC 2615 recommends that a 32-bit FCS be used.
Example
The following command example sets the FCS to 16 for port 1 of the PoS module installed in slot 8 of
the BlackDiamond switch:
config ppp pos checksum 16 ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
1282
Specifies the size of the HDLC frame check sequence (either 32 bits or 16
bits).
Specifies the port number(s).
ExtremeWare Software 7.0.0 Command Reference Guide