Config Vlan Add Track-Diagnostic - Extreme Networks ExtremeWare Command Reference Manual

ESRP Commands

config vlan add track-diagnostic

config vlan <vlan name> add track-diagnostic failover <priority>
Description
Configures backplane diagnostics failure tracking for an ESRP-enabled VLAN.
Syntax Description
vlan name
priority
Default
No diagnostic tracking.
Usage Guidelines
If a diagnostic failure is detected, the ESRP VLAN priority steps to the failover-priority value specified.
By setting the failover priority to be lower than the normal priority of the VLAN, it will cause the
affected VLAN to go into standby.
The range of the priority value is 0 to 254. Setting the priority to 255 configures the switch to standby
mode, and makes it ineligible to become the master. The switch will remain in standby mode even
when the VLAN fails over from the current master.
To make effective use of this feature, the normal priority of the ESRP-enabled VLANs must be higher
than the failover priority of this command.
Example
The following command enables diagnostic failure tracking, and specifies that the ESRP priority for
VLAN esrp-1 be set to 10 upon a diagnostic failure.
config vlan esrp-1 add track-diagnostic failover 10
History
This command was first available in ExtremeWare 6.1.5.
Platform Availability
This command is available on the "i" series platforms.
742
Specifies a VLAN name.
Specifies a number between 0 and 255.
ExtremeWare Software 7.0.0 Command Reference Guide