Config Diagnostics - Extreme Networks ExtremeWare Command Reference Manual

config diagnostics

config diagnostics [extended | fastpost | normal | off]
Description
Runs switch diagnostics at boot-up.
Syntax Description
extended
fastpost
normal
off
Default
Fastpost.
Usage Guidelines
To run diagnostics on an I/O module, use the following command:
run diagnostics [normal | extended] [<slot> | msm-a | msm-b]
To view results of the diagnostics test, use the following command:
show diagnostics
If the diagnostics fail, replace the module with another module of the same type.
Example
The following command configures the MSM64i to run the fastest diagnostics at boot-up:
config diagnostics fastpost
History
This command was first available in ExtremeWare 6.1.9.
Platform Availability
This command is available on "i" series BlackDiamond switches.
ExtremeWare Software 7.0.0 Command Reference Guide
Selects an extended diagnostic routine to run at boot-up. Takes the switch
fabric and ports offline, and performs extensive ASIC, ASIC-memory, packet
switch, and packet loopback tests. This parameter is not supported in
ExtremeWare 6.1.9 or 6.2.
Selects fastpost diagnostic routine to run at boot-up. Takes the switch fabric
offline and performs a simple ASIC test.
Selects normal diagnostic routine to run at boot-up. Takes the switch fabric
and ports offline, and performs a simple ASIC and packet loopback test on all
the ports. This parameter is not supported in ExtremeWare 6.1.9 or 6.2.
Stops boot-up diagnostics.
config diagnostics
1555