Config Ppp User Ports - Extreme Networks ExtremeWare Command Reference Manual

config ppp user ports

config ppp user <name> {encrypted} {<password>} ports <portlist>
Description
Configures the user
requests authentication.
Syntax Description
name
encrypted
password
portlist
Default
The default value of both
Usage Guidelines
The is also sent when a port transmits a CHAP authentication request. The implementation
name
responds to either CHAP or PAP authentication requests issued by the peer regardless of whether the
port is configured to authenticate the peer. The
[1..32] characters. The
characters. If no
password twice (with the second time serving as a confirmation). You should not enter the encrypted
parameter option (it is used by the switch when generating an ASCII configuration).
Example
The following command example sets the name to
of the PoS module installed in slot 8 of the BlackDiamond switch:
config ppp user "titus" "1Afortune" ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the on the BlackDiamond switch. A similar command is available on the
Alpine switch.
ExtremeWare Software 7.0.0 Command Reference Guide
and that the specified PPP port uses in the event the PPP peer
name password
Specifies user name for PPP peer authentication requests.
This parameter option should not be entered.
Specifies the password for PPP peer authentication requests.
Specifies the port number(s).
and
name password
parameter is also a character string, with a maximum length of 32
password
is provided on the command line, then you are prompted to enter the
password
is .
extreme
parameter is a string with a length in the range of
name
and sets the password to
titus
config ppp user ports
for port 1
1Afortune
1285