Configure Qostype Priority - Extreme Networks ExtremeWare Command Reference Manual

configure qostype priority

configure qostype priority [source-mac | dest-mac | access-list | vlan |
diffserv | dot1p] <priority>
Description
Configures the priority of the specified QoS traffic grouping.
NOTE
This command is available only on the "i" series switches.
Syntax Description
source-mac
dest-mac
access-list
vlan
diffserv
dot1p
priority
Default
access-list = 11
dest-mac = 8
source-mac = 7
diffserv = 3
dot1p = 2
vlan = 1
Usage Guidelines
QoS types with a greater value take higher precedence.
Port-based QoS traffic groupings are always the lowest priority. The priority of port-based traffic cannot
be changed.
Example
The following command forces FDB source-mac QoS to take a higher precedence over FDB dest-mac
QoS (with a default priority of 8):
configure qostype priority source-mac 9
History
This command was first available in ExtremeWare 6.2.
ExtremeWare 7.5 Command Reference Guide
Specifies the priority of traffic groupings based on FDB source MAC addresses. Default is 7.
Specifies the priority of traffic groupings based on FDB destination MAC addresses. Default is 8.
Specifies the priority of access-list based traffic groupings. Default is 11.
Specifies the priority of VLAN-based traffic groupings. Default is 1.
Specifies the priority of traffic groupings based on DiffServ information. Default is 3.
Specifies the priority of traffic groupings based on dot1p information. Default is 2.
Specifies a priority value in the range of 0-15.
configure qostype priority
441