Extreme Networks ExtremeWare Command Reference Manual page 440

QoS Commands
parameter unless specific situations and application behavior indicate. You must reboot the switch for
changes to this parameter to take effect.
For ExtremeWare 4.0:
• Only four priority levels are available (low, normal, medium, and high).
Examples
The following command configures the QoS profile parameters of QoS profile qp5 for specific ports on
an "i" series switch:
configure qosprofile qp5 minbw 10% maxbw 80% priority highHi ports 5-7
The following command configures the buffer size for QoS profile qp5 on an "i" series switch:
configure qosprofile qp5 minbw 10% maxbw 80% priority highhi minbuf 3% maxbuff 1024K
History
This command was available in ExtremeWare 2.0.
The minbuff, maxbuff, and ports arguments were available in ExtremeWare 6.0.
Platform Availability
This command is available on the "i" series platforms only.
440 ExtremeWare 7.5 Command Reference Guide