Power Mirrors
Power Mirror Actuator Replacement
1. Remove the power mirror (see page 20-15).
2. Carefully remove the mirror holder from the mirror
housing. Gently pull it out by hand (see page 20-151.
3. Disconnect the connector.
4. Remove the cover, then remove the two Torx
screws from the mirror connector.
5. Record the
terminal locations
and wire colors.
6. Cut the wire harness with the wire cutter.
7. Remove the three screws, and separate the mirror
housing from the mirror base.
22-118
8. Remove the three Torx screws, and separate the
actuator (A) from the mirror housing (B).
9. Route the wire harness (A) of the new actuator
through the hole in the bracket (B) .
.________8