Verifying Imported Device Configurations; Using Device Monitor; Using Device Manager - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Verifying Imported Device Configurations

128
Import the device configuration:
2.
Right-click the device in the Device Manager and select Import Device from the
a.
list.
In the Device Import Options dialog, check Summarize Delta Config if desired.
b.
Click OK, and then clickYes.
The Job Information dialog shows progress, or you can monitor progress in Job
Manager.
The next step is to verify the imported configuration using the Device Monitor or the
Device Manager. See "Verifying Imported Device Configurations" on page 128 for details.
After importing a device, verify that all device information was imported as you expected.

Using Device Monitor

The Device Monitor tracks the status of individual devices, systems, and their processes.
After you import a device, check the status of that device in Device Monitor, located in
Realtime Monitor.
The imported device should display a configured status of "Managed" and a Connection
status of "Up", indicating that the device has connected and the management system
has successfully imported the device configuration.

Using Device Manager

In the security device tree, ensure that the device exists. Open the device configuration
and check the following values:
Ensure that the imported device serial number matches the serial number on the
physical device.
Ensure that the imported device IP address matches the IP address for the physical
device.
Ensure that imported device administrator name and password are correct for the
physical device.
NOTE: All passwords handled by NSM are case-sensitive.
Ensure that interfaces on the imported device are correct for the physical device.
Copyright © 2010, Juniper Networks, Inc.