Create A Polymorphic Object; Add A Polymorphic Object To A Pre/Post Rule - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
532
"Create a Polymorphic Object" on page 532
"Add a Polymorphic Object to a Pre/Post Rule" on page 532
"Map a Polymorphic Object to a Real Value" on page 533

Create a Polymorphic Object

This procedure assumes that a Central Manager administrator is logged onto a Central
Manager client.
To create a polymorphic object:
In the main navigation tree, select Object Manager.
1.
Select one of the following objects that can be polymorphic objects:
2.
Address
Service
Zone
Global NAT
Routing Instance
Click the Add icon in the toolbar and select Polymorphic Address to open the Add
3.
Polymorphic Address dialog box.
Enter the following information for the new polymorphic address, then click OK:
4.
Name
Color (optional)
IP version- IPv4 or IPv6
Comment (optional)
NSM adds the polymorphic address object to the address tree.

Add a Polymorphic Object to a Pre/Post Rule

This procedure assumes that a Central Manager administrator is logged onto a Central
Manager client.
To create a polymorphic object:
In the main navigation tree, select Policy Manager > Central Manager Policies.
1.
Select either Central Manager Pre Rules or Central Manager Post Rules.
2.
Click the Add icon in the toolbar and select Polymorphic Address.
3.
Copyright © 2010, Juniper Networks, Inc.