Verifying Imported Device Configurations; Using Device Monitor; Using Device Manager - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Verifying Imported Device Configurations

Using Device Monitor

Using Device Manager

Copyright © 2010, Juniper Networks, Inc.
Importing a Secure Access Device on page 11
Creating and Applying a Secure Access Device Template on page 29
After importing a Secure Access device, you should verify whether all device information
has been imported.
The imported device configurations can be verified in any of the following ways:
Using Device Monitor on page 19
Using Device Manager on page 19
Using Job Manager on page 20
Using Configuration Summaries on page 20
The Device Monitor in NSM tracks the status of individual devices, systems, and their
processes. To check the status of the imported device in the Device Monitor, from the
left pane click Investigate, expand Realtime Monitor, and select Device Monitor. From
the Device Monitor workspace, check the following parameters for your imported device:
The Config Status must be Managed.
The Conn. Status must be Up.
Using the Device Manager in NSM you can verify the configuration settings of the imported
device. To verify the configuration settings, click Configure, expand Device Manager, and
select Devices List tab.
Ensure that the following parameters are indicated:
Imported device serial number matches the serial number on the physical device.
Imported device IP address matches the IP address for the physical device.
Imported device administrator name and password are correct for the physical device.
NOTE: All passwords handled by NSM are case-sensitive.
Imported device interfaces are correct for the physical device.
Management system successfully imported all device configuration information,
including zones, virtual routers, and routes.
Chapter 3: Adding Secure Access Devices
19