Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual page 637

Copyright © 2010, Juniper Networks, Inc.
Ethernet1 is the Trust IP (10.2.2.1/24) in the Trust zone.
Ethernet3 is the Untrust IP (2.2.2.2/24) in the Untrust zone.
Create the address objects that you will use to create Protected Resources (for details
2.
on creating or editing address objects,. If you imported a security device, the address
book objects configured on that device are automatically imported as Aaddress objects
into the NSM UI.
a. Add the Tokyo Trust LAN (10.1.1.0/24) as a network address object. In Address
Objects, click the Add icon and select Network. Configure the following, then click
OK:
For Name, enter Tokyo Trust LAN.
For IP Address/Netmask, enter 10.1.1.0/24.
For Color, select magenta.
For Comment, enter Tokyo Trust Zone.
b. Add the Paris Trust LAN (10.2.2.0/24) as a network address object. In Address
Objects, click the Add icon and select Network. Configure the following, then click
OK:
For Name, enter Paris Trust LAN.
For IP Address/Netmask, enter 10.2.2.0/24.
For Color, select magenta.
For Comment, enter Paris Trust Zone.
Create the Tokyo Protected Resources object. In Protected Resources (under VPN
3.
Manager), click the Add icon. Configure as shown in Figure 87 on page 588, then click
OK:
Chapter 12: Configuring VPNs
587